Appliqué Tutorial

 


Freezer-Paper-and-Starch Machine Appliqué Technique

 

 

My Supplies

 

Clover mini iron (or other small craft iron)

Stuff-It II tool or stiletto

Spray or liquid starch*

Roxanne’s Glue Baste-it**

Good paper scissors

Small scissors or snips with sharp point

Dark-colored permanent marker

Freezer paper

Lightbox

Stencil brush or soft paint brush

 

*    If using spray starch, just spray it into the lid.  It will foam up, then shrink down into a liquid form.

**  I bought this relatively pricey glue because of the two sizes of handy-dandy needle tips that came with the bottle.  When I ran out, I refilled it with the much cheaper Elmer’s washable school glue, watered down just enough that it flows nicely through the tips.  If the tips get clogged up, unscrew tip and lid, hold it under running hot water, and poke a hat pin into one end and then the other until the glue dissolves.

 



Preparing the Appliqué Shapes

 

Trace each appliqué shape onto the shiny side of your freezer paper, using a dark permanent marker.  I like the fine-tipped ones.  (Do not use washable markers; the starch will make the ink run, it will get on your fabric, and the hot little iron is liable to set it in permanently, ‘washable’ or not.)  Mark with a dotted line those portions of the template that will wind up underneath another piece.  Don’t cut them apart yet.

 

Write the number of each template on the matte side of the paper.  (If you write it on the shiny side, it will wind up backwards.)  The pieces are numbered in the order they will be glued onto the background.

 

With a dry iron, press the sheet of traced templates on top of a second piece of freezer paper, making sure both sheets are shiny side down.  Your tracing and numbers will now be between the two layers of freezer paper, so no permanent ink will get on your fabric.  The freezer paper will stick to your ironing board, but that won’t hurt anything.  Gently pull it away.



 

The double thickness of freezer paper is one of the essential parts of this method, for this will ensure crisp edges to your appliqué.

 

Now you are ready to cut the template shapes.  Use a good pair of paper scissors for this, as it is important that the edges are neat and very precise.  Your appliqué pieces will not be tidier than your template pieces.

 

Next comes one of the parts I especially enjoy:  choosing the fabric.  It’s the perfect opportunity to use up a lot of small scraps.  I like to use as many colors as possible.  Iron the shiny side of the double-thick freezer-paper templates to the wrong side of your fabric.  Be sure the fabrics that will be next to each other have good contrast.  You don’t want to go to all this trouble, if they’re just going to blend together in a mish-mash!  (We will not discuss how I know this.) 



 

Turn on your mini iron (my Clover mini takes longer to heat up than my big iron).  Using good fabric scissors (or snips, if the pieces are very small), cut out the shapes, adding a scant ¼” seam allowance around the freezer paper template.  Leave the paper template in place until you are ready to glue that particular piece onto the background.

 

Pour a small amount of starch into a small container.  Using a small stencil or paint brush, dampen the seam allowance with the liquid starch.  On curved edges, it usually works best to start pressing in the middle of the side.  I do my appliqué pressing on a small board covered tight with pre-quilted Teflon so as not to scorch the ironing board cover.



 

Use the stiletto or Stuff-It tool to fold the seam allowance over the edge of the freezer-paper template, then press with the mini iron, creating a smooth, crisp edge.  (I’ve used a big iron in a pinch, but it sure is a lot more awkward than the mini.)  If your iron gets sticky – and it will – Faultless Hot Iron Cleaner will shine it up again in 15 seconds flat.



 

If your template has points, press all the way to the end of the fabric on one side, then press the other side completely down, creating a little ‘flag’ at the point.  Trim it even or slightly narrower than the opposite folded edge, just enough that it won’t show.  If the fabric is prone to fraying, you might wish to touch the points with June Tailor’s Fray Block.  (Fray Block dries softer and more flexible than Fray Check.)

 

Clip inside curves and inside points fairly close to the freezer paper.  There is no need to turn under the fabric where there are dotted lines, as this edge will be underneath another appliqué piece.

 

Cut your background oversized, as the gluing down of all the little appliqué pieces might pull it up a bit.  Place your complete pattern under the background as a placement guide and lay both pattern and background on your lightbox.  I always use a copy rather than the original pattern, because glue will seep through the background fabric and get on the pattern.  Even if you don’t have a lightbox, you might be able to see the pattern through the background fabric if your fabric is light enough.  My husband made me a large 23” x 23” lightbox by inserting a large piece of Plexiglas into a thick wooden frame, and I slide a flat, square light under the glass.  It has a much more even glow that it appears to in this picture.



  

Attaching Appliqué Pieces to Background

 

Find appliqué #1 – you are ready to begin!  Remove the freezer-paper template now.  (Don’t throw it away; these templates can be reused at least 3 or 4 times, and it certainly saves a lot of time on future blocks to not have to make new templates for each block.)  The edges of the fabric should remain crisply folded under.  Put a thin line or dots of glue along the folded-under seam allowance and set it into place on your background.  If you like trapunto, now is the time to put a piece of batting behind your appliqué piece (though sometimes there are enough layers of appliqué to give the appearance of trapunto without any extra batting at all).  Continue in numerical order until all the pieces are glued down.  If you don’t like the placement, you can easily reposition your pieces.



 

Stitch pieces to the background.  When I don’t want my stitching to show, I match the thread to the appliqué piece and use a very narrow and tight hem stitch, sewing right beside the appliqué and barely catching the edge every fourth stitch.  But my favorite stitch is a narrow blanket stitch (widen or narrow the stitch to correlate with the size of the appliqué).  Try contrasting your thread for a less formal look.



 

Add a bit of embroidery to your appliqué to really dress it up, if you like.  Embroidery shows up best on fabric that isn’t too busy.  Contrast the floss and the fabric, rather than match it.  Trim your block to size – and you’re done! 

 

 

 

Tips and Hints

 

Don’t forget to turn off your mini iron and wash out starch cap, paintbrush, and the needle tip on your glue bottle.  Store glue with the plain lid so glue doesn’t dry in the tip.

 

I have sometimes flipped a pattern over, cut new templates, and made a block in reverse to have opposing blocks.

 

I don’t consider myself an expert artist by any means, but I’m a crackerjack copycat!  I draw most of my appliqué designs while looking at pictures or paintings.  If that doesn’t work for you, another option is to use pencil drawings or coloring pages.  There’s an infinite variety of appliqué-suitable drawings online.  Numbering the pieces in the correct order will be trickier than drawing them.  The Electric Quilt program has numerous appliqué patterns – but the numbering order is not always correct!

 

Try making an appliquéd wall hanging or table runner with felted wool.  You won’t need to add a seam allowance when you cut your fabric, as the wool won’t ravel, and you can do a raw-edge blanket stitch.

 

Someone once said, “The only limitation is your imagination.”  But that’s not really accurate, because, after all, we all learn from each other.  Therefore, the saying should be, “The only limitation is our collective imaginations!”

 

 

-       

    The iris appliqué pattern has 37 pieces.  Try a heart pattern such as this one, if you want something simpler, or something to practice on before launching into the iris design.  I put the heart templates onto some sewn-together strips that were left over from another project.

 


 

No comments:

Post a Comment